Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Another issue with DFM

I have a VPN Firewall (Cisco PIX 520)

all looks good with the device it is being managed by RME, IPM, DFM and CM, however this device is not generating CiscoWork notifications when it goes offline, we had to reboot the device this morning.

What should I look for to make sure this device is configured properly.

4 REPLIES
Cisco Employee

Re: Another issue with DFM

First, make sure the PIX is in a Known state within DFM. Next, check the Reachability Settings polling period for this device (or device class) under DFM > Configuration > Polling and Thresholds > Polling Parameters. Make sure you're polling often enough to catch the reload.

New Member

Re: Another issue with DFM

Hi,

I just checked the device in DFM it is in a known state and as far as the polling parameters everything is at default. Should I change the Reachability settings or something?

Cisco Employee

Re: Another issue with DFM

You might try dropping the reachability polling from four minutes to say, two minutes.

New Member

Re: Another issue with DFM

I will do make this change now......thanks for the help.

121
Views
0
Helpful
4
Replies
CreatePlease to create content