Does Anyone know if i can send commands to execute rsh config mode? i need send commands to my router for change configuration parameters and i don't know if i can send rsh commands for that and if anyone know another way. Thanks!!!
To enable the Cisco IOS software to receive incoming remote shell (rsh) protocol and remote copy (rcp) protocol requests, customers must configure an authentication database to control access to the router. This configuration is accomplished by using the ip rcmd remote-host command.
The no ip rcmd rsh-enable command does not prohibit a local user of the router from executing a command on other routers and UNIX hosts on the network using rsh. The no form of this command only disables remote access to rsh on the router.
For more information on rsh please click following link:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...