we have RME 4.1.1 version....but config archive failed for 4510R switches...Error it was showing related to PKG.but when we are trying to download we have found for CAT400IOS.Zip file from the standard link but it doesn't contain any .exe file ..
Kindly let me know weather RME 4.1.1 support 4510R switch...
The Cat4500-R with sysObjectID 18.104.22.168.22.214.171.124.537 is supported in RME 4.1.1 Cat4000IOS package 5.2. The Cat4510-R-E with sysObjectID 126.96.36.199.188.8.131.52.877 is supported in the same package.
The package .zip files must NOT be extracted. They should be installed using either the Common Services > Software Center > Device Update interface or using the PSUCli command line tool.
When downloading package updates from Cisco.com, you should download and install all available Common Services and RME packages as there are dependencies which must be resolved for packages to install and operate properly.
If you have a problem installing a package, and you are running on Windows, your RME package repository could be damaged. In that case, you will need to open a TAC service request to get the instructions for fixing this.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...