Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Archive Mgt - Config changes

I'm seeing CiscoWorks update the Archive based on the following changes in the configuration. When I do a compare of configs is says that the clock period has changed???

ntp clock-period 36028913

Is this normal, I'm not too sure what this command really does?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Archive Mgt - Config changes

This command should be ignored by config archive. However, we have seen some instsnaces where certain device classes did not have this command in their list of excluded commands. It's easy to fix. Go to RME > Admin > Config Mgmt > Exclude Commands, and add "ntp clock-period" to the list of excluded commands for this device type.

The typical list for IOS devices is:

end,exec-timeout,length,width,certificate,ntp clock-period

2 REPLIES
Cisco Employee

Re: Archive Mgt - Config changes

This command should be ignored by config archive. However, we have seen some instsnaces where certain device classes did not have this command in their list of excluded commands. It's easy to fix. Go to RME > Admin > Config Mgmt > Exclude Commands, and add "ntp clock-period" to the list of excluded commands for this device type.

The typical list for IOS devices is:

end,exec-timeout,length,width,certificate,ntp clock-period

New Member

Re: Archive Mgt - Config changes

good tip... thanks jclarke....

128
Views
5
Helpful
2
Replies