Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Authentication with TACACS+ ACS failed

I have been getting the following pop-up upon opening a new window.

"Authentication with TACACS+ ACS failed. You are in the fallback mode.

To revert to CiscoWorks Local mode, you have to run:

NMSROOT/bin/perl NMSROOT/bin/ResetLoginModule.pl.

You must have appropriate privileges on the system to run this script.

Note: NMSROOT is the product installation directory."

How do I go about configuring my TACACS+ ACS server as well as CW to avoid this?

1 REPLY
Cisco Employee

Re: Authentication with TACACS+ ACS failed

Here is a write up that was original produced by TAC that takes you step-by-step through basic LMS/ACS integration:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddd5a10/0#selected_message

This should take care of this problem for you.

326
Views
0
Helpful
1
Replies