I am trying to verify the autoinstall on Cisco ASR1001. I see that the autoinstall kicks in on the Serial interface. But I do not see an IP address being assigned to the Serial interface during autoinstall.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: n
Would you like to terminate autoinstall? [yes]: n
Please Wait. Autoinstall being attempted over Serial0/1/0 !!!!!!!!!!!!! %Encapsulation SMDS is not supported on this interface!
Then after this, the router just boots up with no config. S0/1/0 is connected to another serial interface with an ip address and HDLC encap;
Staging_Router#sh run int s0/2/0 Building configuration...
Current configuration : 118 bytes ! interface Serial0/2/0 ip address 10.0.0.1 255.255.255.0 ip helper-address 192.168.251.12 clock rate 4000000 end
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...