Announcements
Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Automated Actions not working After Upgrade 2.5.1 to 2.6

I have setup to get automated actions for daily reports, port shutdown alert etc. by email, but after upgrading from 2.5.1 to 2.6 it is not working, I check the automated actions all are enable. ANY CLUE...

  • Network Management
1 REPLY
Cisco Employee

Re: Automated Actions not working After Upgrade 2.5.1 to 2.6

For Automated Actions to work, a lot has to happen. First, the syslog messages need to make it from the devices to the syslog message file on the server (e.g. syslog.log on Windows and syslog_info on Solaris). Next, those messages need to be picked up by SyslogCollector, pass through all configured filters, and be sent to a subscribed SyslogAnalyzer. Once the SyslogAnalyzer receives the messages, it can then execute the automated action.

So if AAs are not working, something in that system is broken. More information is needed to figure out where. Are the messages making it to the syslog file on the server? Are they being written into the RME database such that you can see them in the Standard Report?

105
Views
0
Helpful
1
Replies