I was wondering if there is a way to set up Ciscoworks to remove old devices from the database once it's not detected for certain period of time. Like if I remove a device from the network is there a way to tell Ciscoworks to remove that device if it can't be reachable for say 7 day or whenever I choose for it to be removed. Or if a device gets re-ip'd will it go out and remove the old device and when it discovers the new
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...