Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Automating the suspension of fault monitoring

I have a need to do two tasks, one to suspend monitoring and alerting with DFM for a maintenance window. It will take all the access to devices down for 3 hours.

Second, I also get requests from other engineers that they have a change and they (due to me sending them alerts!) have started requesting suspension of a device and or a site for a period lalala, while they do a change.

I need to do this automatically, or I will have to get up at 0200! I really really dont want to do that.

Any help? Can I use the CLI to do this? Maybe a cmd file with the Wait command? Thanks,

1 REPLY
Cisco Employee

Re: Automating the suspension of fault monitoring

You asked a similar question before:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc2e906/0#selected_message

You can put these CLI commands into a script, and schedule the script to run using the Windows Scheduler system (i.e. the AT command).

After the window is over, you can have another script runs that re-manages the devices.

97
Views
0
Helpful
1
Replies
CreatePlease login to create content