05-02-2006 01:50 PM
hi
I need know like is consumption the bandwidth link by application (http, ftp, smtp) in a router with C2801-ADVIPSERVICESK9-M IOS
I enable in the router nbar protocol-discovery but it does not indicate the consumption in percentage on the bandwidth during a certain period of time
05-02-2006 02:35 PM
If the router have the NM-NAM installed, that can help with this as well.
05-03-2006 07:51 AM
hi rmushtaq
I don't have the NM-NAM, I need know if is possible only with IOS or any software
05-04-2006 03:31 AM
To enable you need "ip nbar protocol-discovery" on the interface and (I think) "ip cef" global command.
Then
"show ip nbar protocol-discovery interface
should show you an actual bitrate. If you need a percentage divide the bitrate shown by the max bandwidth available on the interface. Also I think that the reporting period can be controlled with the "load-interval" interface config command - default is 5 minutes but can go as low as 30secs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide