interface GigabitEthernet0/1.2 encapsulation dot1Q 1 ip address <IP-ADDRESS> <MASK> ip nbar protocol-discovery ipv4 ip flow ingress ip flow egress !
But, on the PRTG it doesnt import/receive the flow.
Because of the source command in RED above.
I use show ip flow and this is what it shows>
Router#sh ip flow export Flow export v5 is enabled for main cache Export source and destination details : VRF ID : Default Source(1) <IP-ADDRESS> (GigabitEthernet0/1.1) Destination(1) 10.10.10.10 (1000) Version 5 flow records 50914209 flows exported in 1697147 udp datagrams 0 flows failed due to lack of export packet 0 export packets were sent up to process level 0 export packets were dropped due to no fib 0 export packets were dropped due to adjacency issues 0 export packets were dropped due to fragmentation failures 0 export packets were dropped due to encapsulation fixup failures Router#
Am I doing something wrong here?
Is there a way to activate the SOURCE simultaneosly?
P.S.: Without the commands in red it doesnt work.
P.S. 2: I tried to use the interface and not the sub-if
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.