Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth Optmization of 3550 L2 port

I have a 3550 switch, onthe 27th port with is and l2 port my service provider is terminating its router. Since the permination point an my end is L2 switch so i m not been able to use Mrtg or PRTG to monitor the traffic is there any way to do that , just want to check utilization of this L2 port.

1 REPLY
New Member

Re: Bandwidth Optmization of 3550 L2 port

Hi!

To use MRTG o PRTG or any snmp based graph tool your switch must have a L3 interface , you need a interface vlan .

Config sample:

Your mrtg/prtg must be on the same segment of vlan1 address.

interface Vlan1

192.168.0.1 255.255.255.0

!

snmp-server community mrtg2008 RO

100
Views
0
Helpful
1
Replies