Which Cisco Works application can be used to configure to monitor the Bandwidth Utilization - Application Specific (HTTP, Citrix, SAP etc.,). Can we also configure the Threshold for the Bandwidth Utilization with Application Specific.
For this, I recommend using netflow and then you can breakdown by application (if you know the relevant ports) and do alarming, depending on how you implement the netflow tools. There are quite a few guys on here from commercial netflow tools, but I prefer flow-tools and JKFlow and present the rrd with cacti.
About the closest you will get to these measurements in Cisco Works will be IPM. This app measure IP SLA and can do some specifics like HTTP or ICMP. However, it won't do all of the above and really isn't mean to measure bandwidth.
If you really want to measure bandwidth you'll want to use a NAM which can measure the above and break it down for you on the application level.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...