Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Baseline template command still not compliant after deploy

In the baseline template for in this case a Catalyst 3560 access switch I entered the following command:

+ banner motd ^<NL>************************************************************************<NL>* *<NL>* *<NL>* Warning: Access for authorized personel only! *<NL>* *<NL>* Use by unauthorized persons is prohibited. *<NL>* *<NL>* *<NL>************************************************************************<NL><NL>^

When I deploy this to the switch and check the config in the switch the command is correctly entered by LMS 3.0 in the running and startup config.

When after this I run the same template compliance check, it states "not compliant" and when I check the details of the job it's telling me that this command I just deployed with the tool is not compliant.

I noticed that this is not the only command that fails after a deploy in the same way.

If anyone ran into the same problem, please share your thoughts, thanks.

2 REPLIES
Cisco Employee

Re: Baseline template command still not compliant after deploy

Try using quotes to delimit the banner instead of ^.

New Member

Re: Baseline template command still not compliant after deploy

That did it, thank very much!

148
Views
0
Helpful
2
Replies