Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Baseline Templates - Interface Configuration

We're checking compliance on all FA ports for switches using standard config settings:

+switchport mode access

+switchport access vlan xxx

+switchport port-security

etc.

However, sometimes an AP hangs off a FA port or even a switch and want to build some logic in to handle those interfaces. Doing [#(access|trunk)#] handles the trunk issue, but it seems like it should be if trunk then a different set of checks should be in place.

Can that be done in the templates?

TIA

1 REPLY
Cisco Employee

Re: Baseline Templates - Interface Configuration

308
Views
0
Helpful
1
Replies
CreatePlease to create content