So, I have a Cisco phone that isn't registering. Worked before. Nothing in the configs has changed. It works in other ports just fine, it's just this one. I can see the MAC when doing sh cdp neigh. I can see traffic. I do not see any errors. Just a l...
Forum Posts
Hello gods of tech.One can configure load-balancing within switches, routers, firewalls, and specific load-balancing hardware such as F5 brand devices.Is the reason most deployments use specific load-balancers because of the administrative ease of us...
Hi everyone,I have two Cisco Prime Servers. It was running okay. Until primary switched to the secondary as operational.Version: 3.9 (3.9.0.0.219)Now I see this error:Check Failback Readiness: FailedSYSTEM - CHECK DISK IOPS = Test is successfulNETWOR...
So, we were testing some things in the IT lab today, things we didn't think would do any harm on a live production environment. Well, we were wrong. lol We have it back up now, but I can't stop wondering WHY adding a VLAN (the subnet our CME is in) t...
I am about to configure new voice VLANs for our new phone rollout. Before I configure them, I wanted to make sure WHERE I need to configure them. Do I have to configure new VLANs on the core switch or does it matter?
Hi Evryone,please help how add attribute huawei CIR in and out in the device Cisco Access Registar ?
Resolved! ACS-Guest wifi
What is the password for this wifi?
Does anyone know why it doesn't ping 8.8.8.8 in Cisco Modeling labs (ACL). configure interface g0/0 as DHCP and take an ip 192.168.255.67 but it does not go to the internet
Good afternoon everyone, yesterday I tried to do a lab to test NAT but it doesn't work for me, any recommendation?The pc takes ip from vlan 20///ROUTER//Router>enableRouter#confiRouter#configure tEnter configuration commands, one per line. End with C...
Does anyone know what is OID to get envmon information for nexus93 NXOS? i can get result envmon result from C9500 as follows, but i am not able to get any result from nexus93. cisco 9500:xxxx:~$ snmpwalk -v2c -c public 192.168.10.1 .1.3.6.1.4.1.9....
Hi guys, I need some help converting the bellow eem script to tcl script for a cisco catalyst 9300 switch without the addon license pack ( so i cannot run the eem script without first rebooting the switch which i cannot do) I tried the eem to tcl c...
Hi team, I'am facing an issue related to ACLs on my ASA configuration, I have an ASA conncted to 3 networks :- OUTSIDE, DMZ, INSIDE.My inside network is subnetted on 3 network/vlans. I have to setup some ACL to matche the following requirement : - Co...
Hi team, i have cisco Nexus 9504 chassis switch, so please suggest witch Netfolw version support.
HelloI am trying to configure a SG350 that is already setup with interfaces and vlans and operating in my network. I am using this guidehttps://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-550x-series-stackable-managed-switches/smb5707-confi...
Hi Team, i have a Cisco Nexus 9504 Chassis switch. In this switch, which NetFlow version support. please suggest
