Network Management

Hello, I had a question on establishing a kind of network maintenace procedure.  Is there a template that is available from cisco that I can fill in or follow to create some kind of procedure? Maybe something that can point me in the right direction?...

Hi thereHave a problem coming my way with regards monitoring 3g data usage on an 887 router.  I have yet to play about on one of these boxes so fishing for some advice before the challenge lands on my desk.The router will carry two links - x1 primary...

Hi,we tried to set up the internetfirewall to give lms only access to cisco.com (https) for updates and services.the problem is, lms is asking an akamai ip address (2.19.240.170) for the connection.is this ip always the same or is there also an url t...

Hi all, I would like some advice from anyone who ever see this case. I applied tcl script for filter ipsec error log that log is cosmetic. But my site want to don't see this log from router log. I already create tcl script for filter it out. Ok scrip...

                   Does Prime Infrastructure have a user tracking/UTLite utility?   I'm not seeing it, and it's a vital part of our daily use in LMS.  If not, is there any other way to track usernames with 1.2?Thanks in advance.

Thank you in advance for your suggestions. Regards,

Hello,I am using Cisco Configuration Professional for my studies to CCNA Voice and I have a problem:When clicking on "Telephony settings" following message appears:" Correct the following errors: An internal error has occurred." and I can't change an...

Hello Support forum,I am getting some weir behaviour in my LMS 4.2 setup. I am doing and Archiveupdate job and am receiving a partial success for roughly 1400 devices.  Here is some output.Execution Result:STARTUP CM0057 PRIMARY STARTUP Config fetch ...

Hi,I am trying to setup monitoring for Netflow and it is working but it doesn't seem I am capturing all the traffic as the utilization only shows 1-2%.My current setup is this:ip flow-cache timeout active 1ip flow-export source GigabitEthernet0/1ip f...

Hello everyone,I've been looking over the past days for a solution to offer to our help-desk operators: basically it would be great if they might be able to change switchports vlans on their own, so to release some pressure for this kind of low-level...

Good day to all,LMS discoverd all my devices and updated the DCR. This devices are visible in DFM. For some of this devices i would like to change the threshold values.For some reason the devices are not visible in Monitor->Fault Settings->Seup->Thre...

Hi,we use LMS 4.2.2 to manage our Cisco devices. At the moment all devices are managed with snmpv2. I´ve picked one Catalyst 2960-24TT-L Version 12.2(25)SEE3 and configured snmpv3Here´s the output of show snmp user:User name: ciscoworksEngine ID: 800...