Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Best performance config for a 4500

Being new to getting in the guts of a 4500 I have been advised that for the best performance the fiber ports in my wiring closet should be matched up by ip address on the 4500 fiber ports. That is the 4500 should know the ip address of the switch that is in the remote wiring closet etc. And vice versa that remote switch should know what port it is connecting to. If this is true how does on set that up?

thanks

Gary

1 REPLY
New Member

Re: Best performance config for a 4500

You can configure the interface speed and duplex mode parameters to auto and allow the Catalyst 4500 series switch to negotiate the interface speed and duplex mode between interfaces.Refer URL

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a0080731453.html#wp1068207

95
Views
0
Helpful
1
Replies