Re: Best software that can tell me info about my switches, route
NCS is for wireless for now, it is very similar to WCS in fact with cool improvements. It is prime LMS you are looking for. These two are 2 parts of the Prime Infrastructure bundle and will be joined in future, LMS is not sold seperately anymore though it is possible to upgrade to Infrastructure bundle from an old LMS with upgrade licenses or service contracts
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...