I'm sorry if this topic was discussed on the forum, but the search didn't show suitable results.
I was trying to set BGP peer admin status (OID 22.214.171.124.126.96.36.199.1.3) which has to be "read-writable" (as all documents say) on 7200 router (with IOS c7200-is-mz.123-6f.bin). But when I try to change this value, router says something like "not writable value".
Is it an error in IOS or it has to be so.
I tried to use SNMP v2 and v3 - doesn't matter.
This OID is not writable on the 5300 router too.
Can anyone say how can I change this value, because copying a part of config from tftp is not a good solution for us.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...