Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call Manager/LMS 3.2 Integration

Hello,

I am building CiscoWorks LMS 3.2 from scratch and my two Call Managers come up as unreachable devices.  I've done some searches and found plenty of Cisco documentation speaking about CDP settings for Call Manager but nothing that tells me where to view it or change it.  Can someone tell me what menus I should be looking at in Call Manager in order to verify the SNMP settings?

Any other reason CiscoWorks would be unable to reach these CMs?

Thanks,

Mike

1 ACCEPTED SOLUTION

Accepted Solutions

Call Manager/LMS 3.2 Integration

if the CallManager is marked "unreachable" it is not a problem with CDP. CDP is necessary to find the hardware - this step passed (because it is listed). The next thing that must work is SNMP reachabiliy and this fails. So either the Call Manager has no SNMP community configured or LMS does not know the correct community to use.

If both are ok, access-lists or firewalls are typically blocking SNMP traffic.

here is the documentation for the Call Manager that covers this

Simple Network Management Protocol Configuration

see the section Configuring SNMP Security

2 REPLIES

Call Manager/LMS 3.2 Integration

if the CallManager is marked "unreachable" it is not a problem with CDP. CDP is necessary to find the hardware - this step passed (because it is listed). The next thing that must work is SNMP reachabiliy and this fails. So either the Call Manager has no SNMP community configured or LMS does not know the correct community to use.

If both are ok, access-lists or firewalls are typically blocking SNMP traffic.

here is the documentation for the Call Manager that covers this

Simple Network Management Protocol Configuration

see the section Configuring SNMP Security

New Member

Call Manager/LMS 3.2 Integration

Thanks Martin - that was exactly what I needed.

582
Views
0
Helpful
2
Replies