Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Campus Layer 2 Map pb with VSPAN

Hi

I have a pb with VLAN SPAN configured on the network.

This causes CCM and TOIP router gateway to be seen as CDP neihbors of a lot of the switches (behind their trunk ports) whereas they are only connected to 2 switches.

It is only because of VSPAN, I guess.

But since Campus discovers these devices to be neighbors of almost every device, it leads to an horrible map with speed discrepencies and incorrect links.

Is there a mean to avoid this situation ?

Please help

Caroline

And Campus can't analyse

3 REPLIES
Cisco Employee

Re: Campus Layer 2 Map pb with VSPAN

I have not see this problem with our VLAN SPANs. How do you have the span configured?

New Member

Re: Campus Layer 2 Map pb with VSPAN

La config est la suivante :

monitor session 1 destination interface Gi2/0/24

monitor session 1 source remote vlan 999

monitor session 2 source vlan 1000 rx

monitor session 2 destination interface Gi2/0/23

monitor session 3 source vlan 1000 rx

monitor session 3 destination remote vlan 999

where 1000 is the TOIP vlan and 999 is the remote span vlan

Cisco Employee

Re: Campus Layer 2 Map pb with VSPAN

Sorry, I have not been able to test an RSPAN to see if there is an inherent problem with CDP and RSPAN VLANs. But I have not found any other reports of problems. What is the native VLAN on these trunk ports that are carrying the RSPAN VLAN? If they are 999, try a different native VLAN.

147
Views
0
Helpful
3
Replies
CreatePlease login to create content