Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Campus Manager 4.0.3 neighbours

Why when I run device discovery in Campus Manager 4.0.3 I discover all switches on my network (which I want). These also have the correct neighbours assigned.

But when I run Campus data collect afterwards so that I can use these in topology map Distribution switches dont have any neighbours. I have modified Seeds, IP ranges, and SNMP on the switches. I have even purged the databases incase there was corruption while the database was installed.

The network is quite simple with Core -> Dist Layer3, Dist-> Access Layer2.

Does anyone know a resolution so that I can have the correct links\neighbours with the devices for Topology View?

1 REPLY
New Member

Re: Campus Manager 4.0.3 neighbours

check out the following link for troubleshooting when devices are not discovered :

http://www.cisco.com/en/US/products/sw/cscowork/ps563/products_tech_note09186a0080094949.shtml#topic2

93
Views
0
Helpful
1
Replies