Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Campus Manager 4.0.4 - No ip phones found

Hi Everyone

We have a strange problem.

All network devices are found exept IP Phones and our Callmanagers.

Any ideas?

Greetings

Jarle

  • Network Management
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Campus Manager 4.0.4 - No ip phones found

Indeed without the callmanagers being known, you won't find any IP phones.

Check the SNMP credentials with

http://lms:1741/cwhp/MgmtStatToDev.do?deviceIP=10.10.10.5

with the IP address of your callmanager.

If that is OK then check CDP neigbours on the switch where the callmanager connects.

You may add the callmanager ip manualy to the DCR but it won't "connect" to the switch unless you have CDP configured on it.

Cheers,

Michel

4 REPLIES
Cisco Employee

Re: Campus Manager 4.0.4 - No ip phones found

Are you seeing this problem with User Tracking or topology services?

If its topo services you need to make sure SNMP/CDP are enabled on the CCM

IP Phones will not appear in the topo map, but should appear in UT

Silver

Re: Campus Manager 4.0.4 - No ip phones found

Indeed without the callmanagers being known, you won't find any IP phones.

Check the SNMP credentials with

http://lms:1741/cwhp/MgmtStatToDev.do?deviceIP=10.10.10.5

with the IP address of your callmanager.

If that is OK then check CDP neigbours on the switch where the callmanager connects.

You may add the callmanager ip manualy to the DCR but it won't "connect" to the switch unless you have CDP configured on it.

Cheers,

Michel

New Member

Re: Campus Manager 4.0.4 - No ip phones found

Hi Michel

What credentials does need to be configured in LMS for the Callmanager, so that it can be registrated fully, and IP Phones can be found.

Is SNMP Read enough - or do we need SNMP-Write, HTTP User / Passwords and so on ..... ?

Thanx so far

Jarle

Cisco Employee

Re: Campus Manager 4.0.4 - No ip phones found

For Campus Manager you will need to have a RO comm string configured on the device, CM does not look at credentials such as passwords

115
Views
14
Helpful
4
Replies
This widget could not be displayed.