Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Campus Manager 5.2.1 Data Collection always running and Topology Issue

Hello,

I recently upgraded LMS 3.2 CM 5.2 to CM 5.2.1 in order to use UTU 2.0.

Since that upgrade, I got some problems:

- Campus Manager Data Collection is always in the running state

- If I want to delete an equipement in DCR in CS, I can't because a data collection is always running.

- Sometimes, I got display errors in CM topology services (ie switches are in red while they are reachable).

In Campus Manager Home, Data Collection and UT Acquisition are in idle state.

A server reboot seems to fix those issues but after a while, it does it again.

You will find attached ani logs.

We have also the following error message:

Construction of XML data required for UT in progress. Please try after some time.

Could it be related to CSCtd49439 because we have 2 APs on the network ?

Thanks for your help.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Campus Manager 5.2.1 Data Collection always running and Topo

Yes, the patch will address this issue.  The issue is not just the fact that they are standalone, it is caused by the way the IOS is labeled in ANI and can be seen on other devices also.  The logs show the exception which points to this issue clearly, so the patch should resolve this.

4 REPLIES
Cisco Employee

Re: Campus Manager 5.2.1 Data Collection always running and Topo

Yes, this is CSCtd49439.  You can get a patch for CM 5.2.1 via TAC.

New Member

Re: Campus Manager 5.2.1 Data Collection always running and Topo

Thanks for your answer.

These APs are controlled by a WLC and are not standalone.

Do you think the patch could adress this issue in this case ?

Cisco Employee

Re: Campus Manager 5.2.1 Data Collection always running and Topo

Yes, the patch will address this issue.  The issue is not just the fact that they are standalone, it is caused by the way the IOS is labeled in ANI and can be seen on other devices also.  The logs show the exception which points to this issue clearly, so the patch should resolve this.

New Member

Re: Campus Manager 5.2.1 Data Collection always running and Topo

Thanks, I will ask the patch to the TAC.

456
Views
0
Helpful
4
Replies