in Campus MAnager v4.0.11 for the physical Discrepancy
I'm getting sevrity medium for a Link Speed Mismatch
--------------------------------------------------------------------------------
WINDOW: Discrepancy Details Dialog
EXPORTED: Tue Sep 09 14:01:54 EDT 2008
--------------------------------------------------------------------------------
Type Link Speed Mismatch
Severity Medium
First found 2008/09/04 20:02:15
Description :
[10.8.0.52,GigabitEthernet0/2],[10.8.0.50,FastEthernet0/18]
This link has ports with mismatching interface Speed.
Port GigabitEthernet0/2 on device 10.8.0.52 with ifSpeed 10000000
Port FastEthernet0/18 on device 10.8.0.50 with ifSpeed 100000000
--------------------------------------------------------------------------------
but when I look at both config, I don't see the problem...
10.8.0.52
Port Name Status Vlan Duplex Speed Type
Fa0/24 Vers SW-3-2-A /18 connected trunk a-full a-100 10/100BaseTX
Switch_Salle_3.145#
10.8.0.50
Port Name Status Vlan Duplex Speed Type
Fa0/18 Vers Switch_Salle_ connected trunk a-full a-100 10/100BaseTX
Switch_3-2_A#
Why is that?
I also have issue with severity Low that I would like to remove from the discrenpancy table!
--------------------------------------------------------------------------------
WINDOW: Discrepancy Details Dialog
EXPORTED: Tue Sep 09 14:04:39 EDT 2008
--------------------------------------------------------------------------------
Type UplinkFast not enabled
Severity Low
First found 2008/08/18 15:14:26
Description :
[10.8.0.10]
UplinkFast is disabled on the switch: 10.8.0.10
Note: This discrepancy may not be applicable if the device is not an access layer switch
--------------------------------------------------------------------------------
UplinkFast not enable, how can I remove this physical discenpancy from Campus Manager if the device is not an access layer switch
Merci,
