I have disabled auto mode and manually included my devices which are all in the DCR, i've also checked all the device snmp credentials. After performing a data collection most devices still show up as not managed. Of several 6500's and 7200's only 1 is showing as managed. What can I do to fix this? thx
P.S the abovementioned devices are in my include list. They are not in the exclude list
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...