It is not really a solution but you will get the lines if you have the possiblity to enable CDP for a short period of time on all the devices, start Data Collection, control the way how the map is drawn and if it is ok disable CDP again.
the interconnecting lines will change to be displayed in red but you will have your network drawn.
But be careful you won?t get any updates if some of these links will change. With 160 devices it could be a thought to create a job in netconfig to enable/disable CDP and rerun this procedure over time.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...