Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can i change snmp poll time in PI 2.0 and how to ?

Can i change snmp poll time in PI 2.0 and how to ?

Thanks

Keith Chan

3 REPLIES
Cisco Employee

Can i change snmp poll time in PI 2.0 and how to ?

Hi Keith,

Go to Adminstartion >system settings > SNMP 

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Can i change snmp poll time in PI 2.0 and how to ?

Hi Afroz,

May i know the default time of snmp polling is 5mins? Can i change it to 3mins ?  I just see the retries and timeout value, could you help ?

Keith Chan

Cisco Employee

Can i change snmp poll time in PI 2.0 and how to ?

Hi Keith ,

yes it is 5 min by default .

You would need to create a new Monitoring template for this and deploy on the 
devices on which you would like to change the polling frequency.
Go to Design --> Monitor Configuration --> Metrics
Choose the type of polling template i.e. Interface health or Device Health etc 
..
Change the values and save it as a new template and deploy.

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
133
Views
0
Helpful
3
Replies