Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I force install ciscoview after lms 2.6 has been done?

I was installing lms 2.6 onto a server that already had Cisco Security Manager installed. It had common services 3.0.5 already installed. When I went to intall ciscoworks lms (doing an upgrade install) the common services disk which has ciscoview on it was version 3.0.3 and would not install. The rest of the installs of lms went ok, but I do not have Ciscoview. Anyone know how to install Ciscoview after the install?

Thanks.

3 REPLIES
Cisco Employee

Re: Can I force install ciscoview after lms 2.6 has been done?

You cannot install LMS and CSM on the same server. You need to remove the LMS applications, and install them on a separate machine.

New Member

Re: Can I force install ciscoview after lms 2.6 has been done?

What did I mess up by installing lms on top of csm? they run the same common services and it appears to have integrated ok. the csm menus appear inside common services and I can hit the links...

Cisco Employee

Re: Can I force install ciscoview after lms 2.6 has been done?

The two are explicitly not supported together because the two were never tested together. While it may work fine, you will not be able to get any TAC support on this configuration.

107
Views
0
Helpful
3
Replies
CreatePlease login to create content