Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Can't access WS-SVC-NAM-2 module through http or ssh...

I'm trying to manage NAM module through GUI or SSH.  Both https and ssh sessions are timing out.  I can ping the module.  I checked the config against the other NAM module that we have.  They are identical.  But, it won't work.  I already tried to reset the module.

root@# sho ip
IP address:               X.X.X.X

Subnet mask:            255.255.255.248
IP Broadcast:           X.X.X.X

DNS Name:               XXXXX
Default Gateway:        X.X.X.X

Nameserver(s):          X.X.X.X

HTTP server:            Disabled
HTTP secure server:     Enabled
HTTP port:              80
HTTP secure port:       443
TACACS+ configured:     Yes
TACACS+ primary server: X.X.X.X

TACACS+ backup server : X.X.X.X

Telnet:                 Disabled
SSH:                    Enabled

Any suggestions?

thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Can't access WS-SVC-NAM-2 module through http or ssh...

This sounds like CSCee10005.  To confirm, try changing the NAM's default gateway to be an IP address not on the switch in which the NAM is installed.  If that works, you can configure "fabric switching-mode force bus-mode" on the switch to change the switching mode to bus mode for all affected service modules.


2 REPLIES
Cisco Employee

Re: Can't access WS-SVC-NAM-2 module through http or ssh...

This sounds like CSCee10005.  To confirm, try changing the NAM's default gateway to be an IP address not on the switch in which the NAM is installed.  If that works, you can configure "fabric switching-mode force bus-mode" on the switch to change the switching mode to bus mode for all affected service modules.


New Member

Re: Can't access WS-SVC-NAM-2 module through http or ssh...

Thanks Joseph.  It worked when I point the default gateway to other switch that's in same subnet.

544
Views
0
Helpful
2
Replies
CreatePlease to create content