Scenario: 1 PC connected to Linksys WRT54G router connected to PIX 501 firewall connected to Cable modem to the internet.
The Pix Firewall is a borrowed one from work where the boss cant remember what address or password he left it in, been sat on a shelf for the past year. I am trying to set it up and play with this, but cannot get an IP adress from the pix so dont actually know what he had it at. again password unknown.
I am trying to reset the pix firewall to default settings but cannot find the address... Is there an easy way to find the address and reset the password.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...