I have a remote office. I need to configure a VLAN for guest internet access. I have created the VLAN and am using sub-interfaces on the router. I want to rate lime traffic to ensure a guest does not take up all the bandwidth. CAR (Committed Access Rate) seems to be the best for this. I want to give them a max of 768kbps. The syntax for this command is a bit confusing to me. Can anyone help me out?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...