Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 3560 - "snmp trap link-status"

Hi Sir,

I'm configuring a Catalyst 3560 to send SNMP linkdown and linkup traps that applies to only a small number of ports.

The global config command is "snmp-server enable traps snmp linkdown linkup". I understand that by default, SNMP link traps are sent when an interface goes up or down via the command "snmp trap link-status".

For my case, I'll disable the trap on all ports (doing a "no snmp trap link-status") and then enable it only on those few ports that require it. Is the other way to accomplish the task?

Please advise.

Thank you.

B.Rgds,

Lim TS

4 REPLIES
Silver

Re: Catalyst 3560 - "snmp trap link-status"

Hi,

As of my understand you would eliminate unnecessary traps comes from the router. Which are really not important. Because of in too many LOGs people are sometimes missing Important LOGs. So you would monitor perticular interface Link !!!!

Okie.

If you would monitor particular interface link :

Command:

Router(config)# snmp-server trap-source ethernet 2/1

If you would monitor ROUTER..with only one interface than .. create one loopback

interface and monitor that.

Regards,

Dharmesh Purohit

Silver

Re: Catalyst 3560 - "snmp trap link-status"

From this link:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t3/dtitraps.htm

"The snmp-server enable traps snmp [linkup] [linkdown] form of this command globally enables or disables SNMP linkUp and linkDown traps. After enabling either of these traps globally, you can disable them on specific interfaces using the no snmp trap link-status command in interface configuration mode. On the interface level, linkUp and linkDown traps are enabled by default, which means that these notifications do not have to be enabled on a per-interface basis. However, linkUp and linkDown notifications will not be sent unless you enable them globally using the snmp-server enable traps snmp command."

HTH

Steve

New Member

Re: Catalyst 3560 - "snmp trap link-status"

Hi Steve,

Thanks for your reply.

Is this behavior also valid on routers?

I did "debug snmp packets" on a router. I did see the following console messages:

SNMP: Queuing packet to

SNMP: V1 Trap ...

when an interface goes up/down.

Kindly confirm.

Thank you.

B.Rgds,

Lim TS

Cisco Employee

Re: Catalyst 3560 - "snmp trap link-status"

This is a fine way of doing it if you only want to send it from a few ports, but using this command on the interface level.

Can't think of another way to do it

11103
Views
0
Helpful
4
Replies