It makes no sense to have CDP running on sc0 since sc0 is a virtual interface. Instead, you want to have CDP enabled on all ports that connect to other managed Cisco devices. This way, you will be able to find all of your directly connected neighbors.
So it sounds like you just want to enable CDP on your supervisor ethernet port (port 1/1, for example). In that case:
Thanks for the response. However, I dont think I can do that because as I mentioned, we have a public and private network. So if I enabled cdp on 1/1 (the uplink), it would be visible on the public net, which my director does not want.
It doesnt sound like there is any way for me to do this then unless the private was plugged into a port other than the mgmt on the supervisor.
EDIT: Unless...if the other ports have cdp disabled, then they shouldnt get any of the advertisements correct?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.