Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change Audit - LMS 3.2

Dear All,

Is it possible to generate weekly or monthly change audit reports..? I could see options only for 24 hours reports.

Thanks in advance 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Change Audit - LMS 3.2

Hi ,

Your devices should be forwarding syslosg to the LMS server  then ONLY the change audit will work as it depends on syslogs.

forward the syslogs to the LMS server and make sure the syslogs are getting forwared in the syslog database .

to check the syslogs state :

got to  RME>Tools> Syslog> Syslog Collector Status   >> you should see syslogs  counts under FORWARED.

Thanks-

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
5 REPLIES
Cisco Employee

Re: Change Audit - LMS 3.2

Hi Prasan,

option is there...

Check the attached screen shot..

Thanks-

Afroz

[Do rate the post if you find it useful]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Change Audit - LMS 3.2

But it shows no records error. What else should i enable to get this ?

Cisco Employee

Change Audit - LMS 3.2

Hi ,

Change audit work on syslogs and you need to create an action based on that.

check the below options that you can use for change audit(Automated Action):

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.3/user/guide/chgaud.html#wp1064457

Thanks-

Afroz

[Do rate the post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Change Audit - LMS 3.2

Thanks for that..

Could you tell me, to generate change audit reports what all steps i should do ..?

i directly tried to get thru report generator but it shows no records for any device.

Do you advise me to do any syslog config..?


Cisco Employee

Change Audit - LMS 3.2

Hi ,

Your devices should be forwarding syslosg to the LMS server  then ONLY the change audit will work as it depends on syslogs.

forward the syslogs to the LMS server and make sure the syslogs are getting forwared in the syslog database .

to check the syslogs state :

got to  RME>Tools> Syslog> Syslog Collector Status   >> you should see syslogs  counts under FORWARED.

Thanks-

Afroz

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
251
Views
10
Helpful
5
Replies
CreatePlease login to create content