Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Changing device hardware and updating LMS 3

Hi,

Lets say I have a 3750 switch and it was successfully discovered and inventoried etc.

If I then swap out that 3750 with a different model of switch (keeping the same hostname/IP/config etc) then what is the best way to update CiscoWorks with the new chassis details etc?

Do I have to manually delete the 3750 from device manager and re-add/discover it ?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Changing device hardware and updating LMS 3

Unless the type is the same (i.e. one model of 3750 with another model of 3750), you should delete the device from DCR, and then re-add or re-discover it. The reason for this is that the inventory and configuration (i.e. hardware/interface data) will be different.

1 REPLY
Cisco Employee

Re: Changing device hardware and updating LMS 3

Unless the type is the same (i.e. one model of 3750 with another model of 3750), you should delete the device from DCR, and then re-add or re-discover it. The reason for this is that the inventory and configuration (i.e. hardware/interface data) will be different.

105
Views
0
Helpful
1
Replies
CreatePlease to create content