Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing Link ports to Access ports in LMS 4.1

One of techs accidentally connected two access ports from different switches together.  Since then, LMS is alerting them as being Link ports down.  I tried to default the config and set them to access ports without any success.  Any idea what I should do in LMS to recognize them as access ports?  Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions

Changing Link ports to Access ports in LMS 4.1

Rediscovering the device is sufficient.

Cheers,

Michel

2 REPLIES

Changing Link ports to Access ports in LMS 4.1

Rediscovering the device is sufficient.

Cheers,

Michel

New Member

Changing Link ports to Access ports in LMS 4.1

Thanks Michel, rediscovering does the trick!

396
Views
0
Helpful
2
Replies
CreatePlease login to create content