check device attributes always show inorrect in telnet and local
The check device attributes always show 'incorrect' the telnet and local user fields. The device is configured with aaa using tacacs+ and local. Telnet password and local username and password were input correctly both in the device and the check device attributes fields.
Re: check device attributes always show inorrect in telnet and l
I also experiencing the same problem.
But this could help u.
Instead of going to Check Device credential report, got to Device troubleshooting-> device center->select the appropriate device -> select Credential verification report.
This should give u the actual report.
Alternatively u can perform the check immediately by selecting the Management station to Device from Tools section(in same device center page) and check all and give the correct SNMP read and write community - telnet username and password will be taken from the DCR and click ok.
This will give the current status.
Try this. Hope it will be useful information if so please rate it :)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...