Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 1841 and 2811 + AIM-VPN/SSL

Hello everyone,

I have i my network HP NNM 7.51 for monitoring. The problem is monitoring the AIM-VPN/SSL CPU utilization. I have it on cisco 1841 and 2811. NNM use SNMP for monitoring. Which MIB and which value should I check for this task?

Best regards,

Michal B.

2 REPLIES
Hall of Fame Super Silver

Re: Cisco 1841 and 2811 + AIM-VPN/SSL

Michal

I am not aware of CPU to monitor in the AIM-VPN/SSL.

HTH

Rick

New Member

Re: Cisco 1841 and 2811 + AIM-VPN/SSL

Thank you Rick,

I was looking for some MIBs for this module but I didn't find anything.

Maybe you're right. But this is strange for me, I can monitor a few MIB objects and why I can't this module?

Best regards,

Michal

153
Views
0
Helpful
2
Replies