Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO 2811 supported MIBs

My 2811 router is running with IOS version 12.4(3g), ADVANCED ENTERPRISE SERVICES. I used MIB Locator and found out that this version of IOS supported CISCO-IETF-IP-MIB and CISCO-IETF-IP-FORWARD-MIB. Question: How can I use my NMS to view the MIBs?

(1) What should I do in my 2811 router side?.

(2)What should I do in my NMS application side?

Here is my assumption: I need to configure community string on my 2811 router but I do not have to install MIBs on my 2811 router. I need to install MIBs and configure community string on my NMS. Is this correct? Thanks

-Henry Lai

1 REPLY
Cisco Employee

Re: CISCO 2811 supported MIBs

Assumption 1: Correct. You need to configure SNMP community strings or SNMPv3 user and group settings. You never need to load MIBs on an IOS device.

Assumption 2: Correct. The MIBs _should_ be loaded on your NMS, but it is not required. SNMP can operation just fine without MIB modules, but the data might not be very understandable by humans.

1114
Views
5
Helpful
1
Replies