Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 6500 series..netflow configuration

In Cisco 6509, while setting the flow mask to interface-full mode I get the following error..

% Unable to configure flow mask for ip protocol: interface-full. Reset to the

default flow mask type: none

Is it a limitation?

2 REPLIES
Bronze

Re: Cisco 6500 series..netflow configuration

Hello,

some features as NAT may require certain flow mask. Do you using some special features (NAT,IPSec,bridging)?

Please, could you send me your current flowmask. (show mls netflow flowmask)

or in better case the full configuration.

Kind regards,

Jan Nejman

Caligare, Co.

http://www.caligare.com/

New Member

Re: Cisco 6500 series..netflow configuration

Hi Jan,

Here are the outputs.

#sh mls netflow flowmask

current ip flowmask for unicast: null

current ipv6 flowmask for unicast: null

Also SUP 720 runs 12.2(18)SXF8 IOS.

Do you have any insights on this.

Thanks

Raj

156
Views
0
Helpful
2
Replies