Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco 7507 bus problems

I have a 7507 with rsp2 in slot2 w/ 128M Dram,64 ata,8 flash. Have cx-fsip slot4,cx-aim slot5,cx-eip6 slot1, vip2-40 w/ pa-fe-tx out of cx-feip in slot0.

It worked fine until it was moved and the modules were pulled and reseated. I thought it might have been the daughter card on the backplane so I pulled the front cover and reseated all the daughter cards. When I put cards only in cybus 0 it works fine. When I load all cards in I get the following errors. There is also a sho ver in the logs. I started logging after boot, OIRd some cards and finally removed them.

1 REPLY
Silver

Re: cisco 7507 bus problems

This looks like a hardware error. I think the card is faulty and has to be replaced. i think the best thing would be to get the cards replaced from the vendor.

96
Views
0
Helpful
1
Replies