Cisco ace Lb is not responding after adding to LMS 4.0
I am trying to add the Cisco ACE loadbalancer to the LMS 4.0 for monitoring. we have two ACE ie A/B. Previous engineer has added ACE-A, but left ACE-B... I have followed ACE-A SNMP config Community strings etc all and applied on ACE-B.
I have added ACE-B with my super admin credentials and it shows clearly in the device list. At the same time, I get two error messages,
a) Operationally down
Note: That when I try to synchronize the ACE-B, then it does not appear in the device list, with an error message, device not found.
Also when adding the ACE-B, it ask for user name/password and then enable password, what credentials is it asking ? I provide my LMS super admin password.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...