Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Blade switch 3120G-S and LMS 2.6

I'm trying to get device support for our new blade switches in Cisco LMS. I've installed the package CBS31x0(2.0), and it seems that CiscoView can correctly deal with the switches. However when I attempt to test the credentials, I get something like " device not supported" for all access methods. I'm sure my credentials are set up properly. Any advice would be greatly appreciated.

thanks,

Peter

4 REPLIES
Cisco Employee

Re: Cisco Blade switch 3120G-S and LMS 2.6

You need to load the RME device package as well. Go to Common Services > Software Center > Device Update, and check the Common Services and Resource Manager Essentials boxes. Click the Check for Updates button. Download and install all available updates.

That said, this device may not be supported yet in RME 4.0.6. What is the sysObjectID of this switch?

New Member

Re: Cisco Blade switch 3120G-S and LMS 2.6

I loaded all the available RME, CWCS device packages. No apparent difference in behavior.

The link below would indicate that this switch isn't supported in RME4.0.6.

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0.5/device_support/table/RME405.html#wp286895

The sysObjectID is 1.3.6.1.4.1.9.1.948

thanks,

Peter

Cisco Employee

Re: Cisco Blade switch 3120G-S and LMS 2.6

Correct. Support for this switch is scheduled for October of this year as part of the Incremental Device Update 21.0.

New Member

Re: Cisco Blade switch 3120G-S and LMS 2.6

Thanks,

Peter

281
Views
0
Helpful
4
Replies
CreatePlease to create content