Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco CGESM switches in RME 4.3

LMS3.2 on Solaris 10

I'm unable to manage in RME the Cisco CGESM switches for HpBlade Enclosure

I'm running cgesm-lanbasek9-mz.122-40.SE.bin image and RME 4.3 device

table says that is is support. Config archive works fine but inventory fails with the following error:

RICS0001:Internal Error,unable to process the collected data from the device

I ran snmpwalk and compared the results with the Cisco 3020 switch and noticed that cgesm switches are missing bunch of mibs including interface mibs. I also tried to add it in the Solarwind and it returned with the error that interface mibs are missing. Please advise.

8 REPLIES
Cisco Employee

Re: Cisco CGESM switches in RME 4.3

How is this switch configured? Post the IC_Server.log.

New Member

Re: Cisco CGESM switches in RME 4.3

Here is the IC_Server.log, I just ran inventory updated which failed again.

Cisco Employee

Re: Cisco CGESM switches in RME 4.3

Where is the running config from this switch?

New Member

Re: Cisco CGESM switches in RME 4.3

Here is the show run and show ver

Cisco Employee

Re: Cisco CGESM switches in RME 4.3

You are seeing CSCso45451. If you upgrade to 12.2(44)SE2 all these problems with LMS and Solar Winds should go away.

New Member

Re: Cisco CGESM switches in RME 4.3

Thank you for your help.

New Member

Re: Cisco CGESM switches in RME 4.3

I have one last quick question, since inventory is not collected for these switches, I will not be able to upgrade the code via CiscoWorks, correct?

Cisco Employee

Re: Cisco CGESM switches in RME 4.3

Correct. You must first do the upgrade manually to get around the bug, then you can use LMS to manage the switch moving forward.

235
Views
0
Helpful
8
Replies
CreatePlease to create content