Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco - Juniper RADIUS setup problem

Hello

I configured a juniper firewall to authenticate with Cisco ACS Radius

and when a request go to the ACS it accepts and pass it (in pass authenticated log) , but juniper log say user authentication failed and rejected by radius server . Is there any specific things that i should configure in ACS as attribute ?

Thanks

Mory

6 REPLIES

Re: Cisco - Juniper RADIUS setup problem

Hi,

MAke sure you set the vendor-specific-attribute for Juniper in ACS. I think the steps are in this link http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_user_guide_chapter09186a008007decd.html#273901

Regards,

Dandy

New Member

Re: Cisco - Juniper RADIUS setup problem

Hello Dandy

Appreciate for ur answer , but i dont know what should i set for Juniper VSA in ACS , do u have a configuration example .Thanks for your kindness .

Regards

Mory

Re: Cisco - Juniper RADIUS setup problem

Hi,

Juniper Vendor ID number is 2636

Attribute:

Juniper-Local-User-Name

Juniper-Allow-Commands

Juniper-Deny-Commands

Number:

001

002

003

Type of value:

string (maximum length 247 characters)

string (maximum length 247 characters)

string (maximum length 247 characters)

Inbound/Outbound:

Outbound

Outbound

Outbound

Multiple:

No

No

No

Regards,

Dandy

New Member

Re: Cisco - Juniper RADIUS setup problem

Dear Dandy

I dont know what should i put for Juniper-Local-User-Name or other juniper attribute values in ACS .

Regards

Dandy

Re: Cisco - Juniper RADIUS setup problem

New Member

Re: Cisco - Juniper RADIUS setup problem

Thanks Dear and sorry about name :))

Mory

879
Views
3
Helpful
6
Replies
CreatePlease to create content