Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco LMS 2.5 - DCA server error

Hi guys,

I couldn't get connection to Common service->devicemanagement. It's showing "Error in communicating with DCA Server.DCA Server may be down."

I have done the self test and the result was "pass" to all services except database.pl. showing error " database.pl

FAIL Self Test Fail to query ani.DbVersion, Error: Database server not found (DBD: login failed)

Self Test Fail to query ani.SYSTABLE, Error: Database server not found (DBD: login failed)

Please Advice..

Regards

GopaKumar

8 REPLIES
Red

Re: Cisco LMS 2.5 - DCA server error

What does the following command return:

pdshow DCRServer

New Member

Re: Cisco LMS 2.5 - DCA server error

Hi,

When I run pdshow DCRServer, it shows never started. I tried to start DCRServer but it is taking long time and hang.

Please advice..

Cisco Employee

Re: Cisco LMS 2.5 - DCA server error

If DCRServer is never started, then one of its dependencies is most likely failing. Please provide the entire pdshow output.

New Member

Re: Cisco LMS 2.5 - DCA server error

Here I have attached the pdshow report. Please review and advice..

Regards

Cisco Employee

Re: Cisco LMS 2.5 - DCA server error

Looks like EDS is down as well as the RME database. First, make sure you have not changed any of your services startup parameters. Services like Tomcat, Visibroker, and the database engines MUST BE set to manual.

Next, what are the specs on this server (i.e. memory, CPU, etc.)? Have you changed the server's hostname since installing LMS?

If the services startup parameters have not been changed, and the hostname is the same as it was when LMS was installed, try resetting the database password for RME:

NMSROOT\bin\perl NMSROOT\bin\dbpasswd.pl dsn=RME

If that completes successfully, the RME database should become accessible.

New Member

Re: Cisco LMS 2.5 - DCA server error

Hi,

I have reset the RME password. The services as you said all are Manual. But still i am getting same problem.

Please find the attached screen shots.

Regards

Cisco Employee

Re: Cisco LMS 2.5 - DCA server error

At this point, I recommend you open a TAC Service Request as detailed debugging is required. Remote access via Meeting Place may also be needed to determine the cause of the problem.

New Member

Re: Cisco LMS 2.5 - DCA server error

Hi,

Here I am attaching some more error snap shots and also self test test info. Please review and advice..

Regards

248
Views
0
Helpful
8
Replies
CreatePlease to create content