Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco LMS 3.0.1 device discovery

Hi,

Just a quick question on device discovery using CDP and SNMP v2.

Scenario:

Site A consist of the following cisco device

Router - 10.10.10.1

Sub-interface VLAN 1 - 10.1.1.254

Switch 1/Vlan 1: 10.1.1.1

Switch 2/Vlan 1: 10.1.1.2

Switch 3/Vlan 1: 10.1.1.3

INTERNET connection

Site B

Router - 20.20.20.1

Sub-interface VLAN 1 - 10.1.1.254

Switch 1/Vlan 1: 10.1.1.1

Switch 2/Vlan 1: 10.1.1.2

Switch 3/Vlan 1: 10.1.1.3

Site A and B uses the same network IP address for the switch stack on VLAN 1 and is only separated by the router and the Internet. If the LMS server is on SITE X, is it possible to discover the switches on both Site A and B?

Site X has VPN connection to Site A and B via VPN.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco LMS 3.0.1 device discovery

This is not possible. Every device must have a unique management address in DCR. You can add the two routers to site X's LMS server, but not the switches at each site. They will not be properly managed.

1 REPLY
Cisco Employee

Re: Cisco LMS 3.0.1 device discovery

This is not possible. Every device must have a unique management address in DCR. You can add the two routers to site X's LMS server, but not the switches at each site. They will not be properly managed.

159
Views
0
Helpful
1
Replies