I need to see if there is a way in the LMS, either through the menu or via a report, that can give me the VLAN numbers, the description, the IP address, the Interface (SVI) the vlan is on and the route it takes.
I've searched near and far and haven't come up with anything yet, so any help is certainly appreciated.
There is one-to-one mapping between a VLAN and SVI, thus only a single SVI can be mapped to a VLAN.
Really, it's a moot point. What I'm getting at is that I need a report in LMS to run that shows what VLANs there are (I've looked at the above post you said in the VLAN menu, but that doesn't get me all I need).
I need a report with VLAN ID, VLAN name, Network it's running on (VLAN 2 = 192.168.0.2 for example), the MASK, ACL IN and ACL OUT applied to VLAN if there is one.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...